After waiting for long time, CISCO has added new data structuted named CSSR in CEF which is actually going to enhance the performance of CEF. It is available on 12.4(20)T platform.
Secret Of CSSR: Actually CEF uses adjacency table for next-hop and mac-address resolution. If you are having n entries in the routing table with the same next-hop then for every entry it has to maintain the adjacency table which acquires more space. By adding new data structure into CEF, it will save only a single entry in the adjacency table for all the routes who are having same next-hop address.
Click Here To Read Rest Of The Post...
SDN and NFV is the next phase of technology change which will help service provider to launch the services in single click. This is all about the programmability of the networks by using open source software defined network controller.
Friday, October 3, 2008
Thursday, October 2, 2008
CEF Troubleshooting With Ping
Few days back I faced problem related to the CEF. I tried to ping from one router to another but found packet drops. SO I initiated the first step with ping. By using extended ping I set the record option and find ping reply.
So what is the difference when we use the ping with record option and without record option. Actually by setting record option ping packets uses the fast switching and without record option it uses the cef switching. So I conclude there might be problem with the CEF in the path.
Shivlu_rtr#ping
Protocol [ip]:
Target IP address: 10.10.20.20
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface: FastEthernet0/0.50
Type of service [0]:
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]: Record
Number of hops [ 9 ]:
Loose, Strict, Record, Timestamp, Verbose[RV]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.10.20.20, timeout is 2 seconds:
Packet sent with a source address of 71.5.100.69
Packet has IP options: Total option bytes= 39, padded length=40
Record route: <*>
Click Here To Read Rest Of The Post...
L2TP Vulnerability

On 24th september, 2008 Cisco has official announced the l2tp vulnerability. A vulnerability exists in the Cisco IOS software implementation of Layer 2 Tunneling Protocol (L2TP), which affects limited Cisco IOS software releases.
Several features enable the L2TP mgmt daemon process within Cisco IOS software, including but not limited to Layer 2 virtual private networks (L2VPN), Layer 2 Tunnel Protocol Version 3 (L2TPv3), Stack Group Bidding Protocol (SGBP) and Cisco Virtual Private Dial-Up Networks (VPDN). Once this process is enabled the device is vulnerable.
This vulnerability will result in a reload of the device when processing a specially crafted L2TP packet.
Recent Post
Click Here
Work Around
Note: L2TP implementations will need to allow UDP 1701, from trusted addresses to infrastructure addresses. This does not provide for a full mitigation as the source addresses may be spoofed.
Note: L2TPv3 over IP only implementations need to deny all UDP 1701 from anywhere to the infrastructure addresses.
Create an iACL
access-list 101 permit udp trusted-address wcm trusted-address wcm eq 1701
access-list 101 deny udp any any
access-list 101 permit 115 trusted-address wcm trusted address wcm
access-list 101 permit ip any any
As shown in picture apply access-list to fa0/0 in direction of Delhi-PE
int fa0/0
ip access-group 101 in
Click Here To Read Rest Of The Post...
Subscribe to:
Posts (Atom)