One of my friend asked a question that can we a communication be possible in point to point link with different subnet ip addresses. I replied him at the same instant yes by adding static route in it and it works fine. But what happens if OSPF or ISIS is used. Under OSPF the neighborship comes up because OSPF neighborship made on the basics of multicast address not on ip address. In case of IS-IS it works on the basics of network Id not on ip addresses.
This can really a good experience becasue in network some one can make this type of mistake and you won't be able to troubleshoot because everthing works fine in it. In the next post I will post the document for this.
Click Here To Read Rest Of The Post...
SDN and NFV is the next phase of technology change which will help service provider to launch the services in single click. This is all about the programmability of the networks by using open source software defined network controller.
Tuesday, October 14, 2008
Communiaction between two different subnets
Monday, October 13, 2008
Recurisve Lookup
When a packet forwards to the destination address the next hop address is checked and corresponding to that next hop address a outgoing interface is selected where the packet actually moves. Let's consider what happens when the routing table receives some prefixes with next hop looopback address of some router. In this case first a route lookup will be checked whether the destination prefix is in the routing table if yes then a lookup is performed for its next hop address becasue in this case next hop address is not directly connected interface. For latter, it will use the recursive lookup. This algorithm will work till it gets the directly connected interface. In most of the cases no recursive lookup will take more than 2 steps.
Actually it is more required in iBGP type of scenarios.
Click Here To Read Rest Of The Post...
Wednesday, October 8, 2008
Support of 1600 MTU
Prior fast ethernet interfaces does not supoprt MTU more than 1500 bytes. But now-a-days the barrior has been closed and cisco has opened the MTU barrior upto 1600 Bytes with the new release of 12.4(20)T. So no more problems in case of MPLS, you can access your applications without fragmentation.
Click Here To Read Rest Of The Post...
Subscribe to:
Posts (Atom)