mturoute is a small command line application that uses ICMP pings of various sizes in order to determine the MTU values on the path between itself and the target system. It also includes a "traceroute" like mode where it will attempt to determine the lowest MTU between the local host and each hop in the communication. The utility generates maybe 100 times as much traffic as a normal ping does, so you should exercise restraint when running it on networks you do not administer. During development and testing my ICMP capability was disabled completely several times, although a power cycle on the cable modem restored normal operation.
You can use it for troubleshooting MTU problems.
Click Here For Download the Utility
For more you can visit
http://www.elifulkerson.com/projects/mturoute.php
Click Here To Read Rest Of The Post...
SDN and NFV is the next phase of technology change which will help service provider to launch the services in single click. This is all about the programmability of the networks by using open source software defined network controller.
Wednesday, October 1, 2008
Cisco IOS MPLS VPN May Leak Information
Devices running Cisco IOS versions 12.0S, 12.2, 12.3 or 12.4 and configured for Multiprotocol Label Switching (MPLS) Virtual Private Networks (VPNs) or VPN Routing and Forwarding Lite (VRF Lite) and using Border Gateway Protocol (BGP) between Customer Edge (CE) and Provider Edge (PE) devices may permit information to propagate between VPNs.
Workarounds are available to help mitigate this vulnerability.
This issue is triggered by a logic error when processing extended communities on the PE device.
This issue cannot be deterministically exploited by an attacker.
Cisco has released free software updates that address these vulnerabilities. Workarounds that mitigate these vulnerabilities are available.
Workarounds
Customers running versions of Cisco IOS that support filtering of extended communities can prevent the corruption of the route target (RT) by applying a BGP route-map that removes RT entries on inbound BGP sessions.
The following configuration example applied in the ipv4 address family of a PE device removes extended communities from the CE router:
router bgp
address-family ipv4 vrf one
neighbor
remote-as
neighbor
activate neighbor
route-map FILTER in exit-address-family
!
ip extcommunity-list 100 permit _RT.*_
!
!
route-map FILTER permit 10
set extcomm-list 100 delete
!
The following configuration example applied in the ipv6 address family of a PE device removes extended communities from the CE router:
router bgp
address-family ipv6 vrf one
neighbor
remote-as
neighbor
activate neighbor
route-map FILTER in exit-address-family
!
ip extcommunity-list 100 permit _RT.*_
!
!
route-map FILTER permit 10
set extcomm-list 100 delete
!
Note: The capability of filtering extended communities is only available in certain 12.0S and 12.2S based Cisco IOS releases.
BGP session between the PE and the CE needs to cleared to make this configuration change effective.
Click Here To Read Rest Of The Post...
Inter-AS Communication-MP-eBGP(Option B)
I have written a document on MP-eBGP(option B) which is widely used by many service provider for inter-as communication.
Click Here For Download
Click Here To Read Rest Of The Post...
Subscribe to:
Posts (Atom)